top of page
Search
lielesubnewsstanac

Bmw X5 Drivers Door Wont Open From Inside Or Outside: A Case Study of a Successful Fix



Every morning if the temp was below zero, the drivers door would not open from the outside, only from inside. Soon as I got to work and the car had warmed up, handle worked fine again. Sometimes when you tried pulling the outer handle in the cold you could feel a 'click', like some connection has slipped or something. If the door will not open, then the issue may be the latch, but it may also be the linkage that connects the handles to the latch. You will need to access the inside of the door panel to have access to the locking mechanism and door latch, as well as verify the condition of that linkage.


Hello. If the door will not open, then the issue may be the latch, but it may also be the linkage that connects the handles to the latch. You will need to access the inside of the door panel to have access to the locking mechanism and door latch, as well as verify the condition of that linkage. With the door shut, you will have limited space to pull off the door panel, but you should have enough room to do so.




Bmw X5 Drivers Door Wont Open From Inside Or Outside



Do to that, you must remove the bolts and pop out the retaining clips around the perimeter (which will be the hard part). Be careful not to break the clips; typically you have space to use a special tool, but you will only have a small amount of space to work with. Once you get the inside door panel off, you will have access to the latch and be able to open the door for the inspection. Manipulate the handles and check the linkage and latch release mechanism. With some simple observation, you should be able to find the issue rather quickly.


Hi. I've got a problem with the passenger door on my E53 which won't open. The actuator seems to work as the button goes up and down but neither the inside or outside handles will open the door. I gave a work colleague a lift home last night and when we got to his house he pulled on the handle, but as the door was locked it wouldn't open on the first pull. He's a ham fisted oaf and was really pulling on it. I told him he had to pull it again to open, which it did.


This morning I picked him up but when he went to open the door, it wouldn't open. I tried from inside, but it still wouldn't open. I locked and unlocked a couple of times but with no luck. I think he may have broken something in the mechanism. The problem is, how do I remove the door card with the door shut, or can't I?


Once the door card is out of the way use a heat gun or hair dryer to soften the adhesive holding the inner membrane and peel it back if you tear it make sure you tape it when it goes back. Awkward to see but inside the door you will see the mechanism with the Bowden cable attached get some lube in there WD40 or similar and with a long screwdriver or bent piece of metal work the mechanism it should operate and you can open the door making life easier. Keep operating the lock and lubricating until its working as it should then I smothered mine in spray grease to protect against water ingress rusting it again (tip don't close the door till your happy all is working as it should guess how I know that!!)


There are several reasons that your door latch may become stuck and prevent the door from opening. Noted below are a few steps you should take, before making the call to a mechanic to inspect why the door won't open.


Many problems with car door latches happen in older vehicles and are the result of normal use. Over time, the components wears out and makes it difficult to open and close. Water can also get in this area and cause rust, which will affect the latch after a period of time. Slamming the door can bend the mechanism on the latch and make it more difficult to open and close. It may cause the latch to get stuck inside because it is slightly bent.


Electronic issues are not limited to your power windows or instrument panel - they can also present themselves in the components of your door. For example, a short-circuit could prevent your locks from disengaging when the door is open, causing the locks to remain engaged. The locks will then act as physical blocks for the door.


Before taking anything apart, it's best to narrow down which entry methods do or do not work and how many doors are affected. First, test that your key fob is working properly by remotely locking and unlocking your vehicle. It could be that your key has simply run out of battery and is no longer responsive. Second, test your key manually in the door's key slot. If this does not open the door, the lock assembly may be jammed or broken. Finally, test the door handles on both sides of the affected doors. It may be that the outside handle does not work while the inner door handle opens just fine, or vice versa. Gaining access to the interior handles may require you to enter your car through one of the passenger doors. If one handle works while the other doesn't, you are likely experiencing a broken connection somewhere in the door assembly. A stuck car door can come down to four possible causes:


7 Series E38 Forum This message is marked as Important. Subject: Outside Door Handle Won't Open Door - ResolvedAuthor: specificimpulse : member since December, 2005 : 16 postsPosted on: 2007-04-06 14:49:44 var addthis_pub="bimmerboard";This is an update FYI to a post I did a while back that's closed now. My outside Left Rear Door Handle started to be difficult to open the door from the outside. Eventually it wouldn't work at all. There is a mechansim bolted to the inside of the door panel called the "carrier" that the door handle locks into. This carrier is made of plastic and a small "journal" had broken that was barely noticible until I bought the new part thinking it was just a lot of freeplay in the gear. Anyways, hear are some pictures in case anyone else has a similar problem.2000 740i Sport2004 R1150R RocksterThe 7 Series E38 Forum Message Thread:


Another thing to try is to open the door from the inside. You might have a stuck mechanism that becomes unstuck by when using the inside door latch. If you suspect the latch is the problem, you can go to step 3 and inspect the latch after opening the door panel.


With the panel removed, you can see what happens when you pull on the door handle. If you cannot open your door from the outside, then take a look at the metal rods on the inside panel. Are they operating correctly?


Again, the coat hanger trick only works on certain lock mechanisms, usually on older cars, so this most likely won't work on newer model cars. For newer cars, you can still use a coat hanger, but you'll have to stick it in between the door and the rest of the car (like in Method #2) to unlock it from the inside.


You can usually remove your car's windshield wipers pretty easily, but the method differs between each car model. No matter what car you have though, a windshield wiper might save you from having to call a locksmith to open your locked car door.


First, remove the wiper from the front of your car. If your window is slightly ajar, or you can wedge the door open, you maneuver it into the interior of the car. Use the wiper to either grab the keys on the chair or hit the unlock button on the side of the door (which I tried out successfully myself in the video below).


Some of these methods will work if your latch is on the side of the door panel inside if you have something to stuck in there and push it away from you, otherwise you need to reach in from the other side of the car with something long enough. It's usually a bigger hassle but it's possible in many cases. 2ff7e9595c


0 views0 comments

Recent Posts

See All

コメント


bottom of page